SIX SIGMA CONCEPT, A PHILOSOPHY OF MANUFACTURING WITHOUT DEFECTS

  • N. Gavrikova FGBOU VO «MIREA- Russian technological university» RTU MIREA, Russia
  • A. Kuzmicheva FGBOU VO «MIREA- Russian technological university» RTU MIREA
  • M. Bogatikov FGBOU VO «MIREA- Russian technological university» RTU MIREA
DOI: https://doi.org/10.31618/ESU.2413-9335.2020.5.80.1133
Keywords: Six Sigma concept, process, analysis, improvement, defect, DMAIC cycle

Abstract

The article discusses the concept of Six Sigma, a philosophy of defect-free manufacturing. The concept of Six Sigma is the foundation of a working quality management system, without which the long-term success of the company in modern realities is impossible.

Author Biographies

N. Gavrikova , FGBOU VO «MIREA- Russian technological university» RTU MIREA, Russia

Senior lecturer

A. Kuzmicheva , FGBOU VO «MIREA- Russian technological university» RTU MIREA

student

M. Bogatikov , FGBOU VO «MIREA- Russian technological university» RTU MIREA

student

References

1. ГОСТ Р ИСО 9000-2015.
2. ГОСТ Р ИСО 13053-1-2015.
3. ГОСТ Р ИСО 50779.100-2017.
4. Зайцев Г.Н. Управление качеством. Технологические методы управления качеством изделий: Учебное пособие. 2014. 272с.
5. Кане М. М., Иванов Б. В., Корешков В. Н., Схиртладзе А. Г. Системы, методы и инструменты менеджмента качества. Учебник для ВУЗов. 2019. 576с. 6. 6 сигм// Портал о менеджменте качества. URL: https://www.kpms.ru/General_info/SixSigma.htm
Published
2020-12-14
How to Cite
Gavrikova , N., A. Kuzmicheva, and M. Bogatikov. 2020. “SIX SIGMA CONCEPT, A PHILOSOPHY OF MANUFACTURING WITHOUT DEFECTS ”. EurasianUnionScientists 5 (11(80), 25-28. https://doi.org/10.31618/ESU.2413-9335.2020.5.80.1133.
Issue
Vol. 5 No. 11(80) (2020): EURASIAN UNION OF SCIENTISTS №80
Section
Article

CC BY-ND

A work licensed in this way allows the following:

1. The freedom to use and perform the work: The licensee must be allowed to make any use, private or public, of the work.

2. The freedom to study the work and apply the information: The licensee must be allowed to examine the work and to use the knowledge gained from the work in any way. The license may not, for example, restrict "reverse engineering."

2. The freedom to redistribute copies: Copies may be sold, swapped or given away for free, in the same form as the original.